![](https://www.portesolympique.com/wp-content/uploads/2013/10/PROH_banner-en.jpg)
Industrial, continuous, duty belt drive jackshaft operator for high lift, vertical lift of sectional doors and rolling doors.
Features
- 24V class 2 control circuit with 40VA transformer to protect against short circuit
- External radio control terminal strip
- Low friction powder metal limit cam nuts with fully adjustable rotary type limit switch assembly
- Three button open-close-stop control station Nema-1
- Continuous duty industrial motor with overload protection
- Motor removable without affecting limit settings
- Heavy duty 5LV-belt
- #41 roller chain and sprockets on all internal drives
- Adjustable friction clutch
- Mechanical brake system
- Solenoid brake(optional PRO-HB)
- #50 roller chain and sprockets on final drive
- 3/4″ permanently lubricated and sealed ball bearings on pulley shaft
- 1″ permanently lubricated and sealed bearings on final drive shaft
- Emergency disconnect with electrical cut-out switch for manual operation
- Chain keeper
- Left or right hand mounting
- Baked on dark grey coat finish
- Shipping weight: 100 lbs
Circuit options
1 (M)
- Heavy duty reversing contactor with mechanical and electrical interlock incorporating the UL325(2010)interface module.
- C2 factory wiring standard(constant pressure close),B2 wiring can be field set by moving 1 jumper and installing Micanan monitored fail safe photo-eyes (supplied) or (optional) Micanan compatible monitored fail safe electric edge
2 (E)
- Full fonction Smart 10.0 Logic conrol board featuring on-board receiver with antenna, enhanced program selection to include B2,C2, D1, E2, T & TS and supplied with Micanan monitored fail safe photo-cells or(optional)Micanan monitored fail safe electric edge
- D1 factory pre-set mode of operation standard(constant pressure open and close)
3
- Heavy duty reversing contactor with mechanical and electrical interlock. (Not available in US or other areas where UL325 (2010)is mandated)
- C2 factory wiring standard, B2 wiring can be field set by moving 1 jumper. Provisions for standard reversing devices.